Date:         Thu, 24 Apr 2003 07:40:59 -0600
Reply-To:     Bob Stevens <mtbiker62@HOTMAIL.COM>
Sender:       Vanagon Mailing List <vanagon@gerry.vanagon.com>
From:         Bob Stevens <mtbiker62@HOTMAIL.COM>
Subject:      Re: replacing lock cylinders + ignition switch
Content-Type: text/plain; format=flowed

A procedure for changing the ignition lock:

This came to me from Daniel Danrich.

Bob Stevens
'87 Syncro Westy "REDDAWG"

All you need to remove is [in this order];
1. ignition key from switch;
2. horn button from steering wheel;
3. 17mm nut that holds down steering wheel;
4. steering wheel;
5. lower steering wheel collum cover [two screws];
6. three screws in top of collum that hold down and align turn
indicator switch assembly/high-low beam assembly and the windshield
wiper switch assembly;
7. disconnect the three different wire harness connectors from the
bottom of the ignition-starter switch and the above mentioned switch
assemblies;
8. upper steering wheel collum cover and switch assemblies;
9. 6mm hex bolt that holds ignition switch housing to collum;
10. place ignition key in switch and turn on to "run" position;
11. using small ballpeen hammer or 1/2" drive socket extention, tap on
bottom of housing till it comes all the way off;
12. turn housing over and using a Reed+Prince type Phillips screw
driver, remove screw that holds the ignition switch to ignition switch
housing;
13. assemble in reverse order;
NOTE:
A. pay attention to the plastic sleave bushing's orientation that came
of collum shaft when housing was removed;
B. pay particular attention to assemly of turn indicator switch together
with high-low beam switch as you place it on collum assembly;
C. good luck!

 > Today a set of keys was stolen from me along with some ID containing my
home
 > address.
 >
 > I'm thinking I will have to change the lock cylinders on my Vanagon
including
 > the door locks and the ignition switch. Anyone have an idea as to the
cost,
 > difficulty, and time, of a lock switch. Easiest and least expensive way
is
 > best of course  i.e. can the lock cylinders be replaced without changing
the
 > door handles and the ignition switch.
 >
 > I'm suspecting the ignition is a PIA and pricey :(
 > TIA
 > Jeff
 > 83.5 Westy


_________________________________________________________________
Add photos to your e-mail with MSN 8. Get 2 months FREE*.
http://join.msn.com/?page=features/featuredemail